Flow Unit Identification Based on Petrophysical Studies Using Well Logging of the Mauddud Formation in Ratawi Oil Field

Authors

  • Mayssa N. Shehab Department of Oil and GasEngineering , College of Oil and Gas Engineering, Basrah University for Oil and Gas, Basrah, Iraq
  • Heba A. Al-Samer Department of Oil and GasEngineering , College of Oil and Gas Engineering, Basrah University for Oil and Gas, Basrah, Iraq
  • Fahad M. Al-Najm Department of Geology, College of Science, University of Basra, Basra, Iraq
  • Mohammed H. Hafiz Department of Oil and GasEngineering , College of Oil and Gas Engineering, Basrah University for Oil and Gas, Basrah, Iraq

DOI:

https://doi.org/10.46717/igj.2026.59.1F.1

Keywords:

Mauddud Formation; Petrophysical Properties; Hydraulic Flow Units

Abstract

The Mauddud Formation, deposited during the Albain Stage of the Early Cretaceous is a hydrocarbon-ric–h reservoir and represents the second economic reservoir after the Yamama Formation in Ratawi oil field. The Mauddud Formation was studied in five wells that were distributed across the field, southern Iraq, open- hole well logs were obtained for these wells. the Mauddud Formation consists mostly of limestone, with shale interbeds, the petrophysical properties results confirmed that the shale volume of the formation is low in most wells, with a porosity distribution ranging from 10% to 26%, and the formation contains different proportions of the produced hydrocarbons. Based on results, the formation was divided into four units: MA, MB, MC, and MD. Through porosity and permeability calculations, the pore type and flow unit were determined based on the pore throat radius (r35) curve. As the results showed that the type of pore ranged between macroport and megaport in unit MA, while in unit MC the type of pore ranged between microport and macroport, these variation indicate reservoir heterogeneity within the Mauddud Formation. The flow units in the Mauddud Formation were identified using the Interactive Petrophysics program, and based on the application of flow zone indicator equations. As the results showed that wells Rt-4, Rt-6, and Rt-7 consist of three hydraulic flow units, while the wells Rt-5 and Rt-3 consist of four hydraulic flow units, reflecting greater heterogeneity in permeability distribution and pore structure.

Downloads

Published

2026-06-30

Most read articles by the same author(s)

1 2 > >>